3D Printer Issues

This section deals with printer level issues

How to avoid Nozzle clogging issues?
1. There is impurity in the filament which got stuck in the nozzle. Please clean  the nozzle using a needle or take the nozzle off and clean inside of the ...
Wed, 27 May, 2015 at 2:04 PM
Q: The nozzle heating failed
1.The heating tube connection is too loose. Please tighten the connection. 2. Heating tube/ temperature controller/ power tube damage. Pleas...
Wed, 27 May, 2015 at 2:13 PM
Q: MAXTEMP/ MINTEMP
1. Nozzle temperature is too high.  Please reduce the nozzle preset temperature.  2. Temperature controller damage.  Please replace the temperature ...
Wed, 27 May, 2015 at 2:11 PM
Q: Print Head Stuck/Cannot move
1) Please clean the axes and smear the lubricating oil evenly. 2) The deformation of machine framework caused by external force during the  transpo...
Wed, 27 May, 2015 at 2:59 PM
Q: Print head hit the framework
The connecting wires of limit switch get loose or the limit switch is broken. Please  check if the wires connecting limit switch and main board are loose. ...
Wed, 27 May, 2015 at 3:22 PM
Q: Filament Feeder Motor make intermittent noise
1. The clamp of the feeding device is too tight. Loosen the screw of the clamp. 2. Nozzle clogging, causing the filament not to be fed smoothly. Ple...
Wed, 27 May, 2015 at 4:11 PM
Q: Even after the screws under build plate are loosened totally, the build plate still is far away from the nozzle (the gap between build plate and nozzle is too big to be adjusted).
Adjust Z axis limit switch on the back the printer, raise it a little bit; Even after adjusting if problem still exist, the main cause might be deformation ...
Wed, 27 May, 2015 at 6:05 PM
Q: The Z-axis movement of the build plate is abnormal.
1. The top of the Z-axis screw is loose.  Please reinforce the screw at the top of the Z-axis screw.  2. Z-axis motor loose connections.  Please ope...
Thu, 28 May, 2015 at 3:43 PM
Q: No filament output from the nozzle.
The filament has not entered into the end of the nozzle yet when you feed the  filament. slightly try pushing the filament from the feeder end.
Thu, 28 May, 2015 at 3:50 PM
Q: Model is easy to fall off
Kapton tape not used or the Kapton tape loses stickiness; Or the model bottom  is too small, you can use a hot melting glue gun to help; Adding support  st...
Fri, 29 May, 2015 at 4:18 PM